If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've got belt driven walk behinds that have bad transmissions (sheath moves on the input shaft) where can I find a rebuild kit for these transmissions?
I would just replace the whole tranny. rebuilding them seems to be a pain in the a$$. It takes about 2 hours to replace on if you dont know what your doing once you get comfertable with it you can do it in about 45 min.
I pulled the trans off one of my other toros that is waiting on a new wiring harness (figured I'd put the new transmission on the better mower) after taking a known good transmission and putting it on this machine. it still pulls sluggish especially going up hill, and turning. is there a way to adjust the drive belt under the mower? Idler arm is snug, belt seems snug when its off..... I'm running out of ideas unless the pulley on the motor is to big?