Hello everyone! My problem is quite simple to explain but complex to solve! When I press on the primer bulb there's no gas getting to it. I cleaned the carb and put a new kit on it last night and I'm still getting the same problem. I can hear the gas moving in the tank as I press the but it not reaching the bulb. Just to add to the information so I can get a accurate response... The fuel line that's connected to the filter is allowing gas and air to leak out around the little rubber washer on the fuel tank and when I put my finger over it I can see the gas starting to go up the fuel line but it stops right there by the carb and goes no further. Have any of you guys every dealt with this before? any advice would be helpful!
No announcement yet.
Stihl Fs80R Problems!!