Ok so I am not the best at engine repair so I hope someone here can advise me. My old mower finally caved in while on a job not long ago. I replaced it and didn't skip a beet. Once I got home and got everything cleaned off I replaced the primer bulb which looked melted inside, replaced a badly fouled plug and completely cleaned the carb and tank. I reassembled it and took it out back and it ran great I had a job to do today where the client typically lets the grass get 2-3 feet tall before calling. I figured rather than abuse my new mower I would use the old one. Well after 30 minutes of use the plug fouled again and I was forced to use the new one. Did I miss anything or is my old mower simply burned out? I am thinking the rings are dead and allowing oil into the combustion chamber. Any thoughts?
No announcement yet.
Bottom Ad Widget