If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Well the Rzt doesnt have clearance behind the deck so off the back was all I could really do but I am adding a bracket to bring the angle closer to the ground so I dont have to be soooo careful in reverse (it wants to go under) as for the push mower I ripped off the design of http://patternyourlawn.com/
They are both filled with dirt and rocks.
How I made it....I found the 4" pipe after a trailer moved and left it so I went to Home Depot and paid about $7 for each of the end caps and $4.50 for a 3' threaded rod I think it was 5/8" thick and like $1 on nuts and washers and I had the two flat metel brackets already.
So basically drill a hole in each cap
Put one cap and pipe on
put washer next to pipe the a nut
fill with sand or dirt
put the other cap on washer then nut
put your brackets on
then two nuts on both ends and tighten together so it can roll