If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I like the idea, but I don't think the design is going to hold up to the wind while being pulled behind your vehicle. If you could use a stronger frame and have it welded to the mowers frame or something, then it might be long lasting. Let us know how it works for you.
It is just an iron sign holder with the legs turned in so it sits flat on the mower...the mower already had the holes there. With the highway issue I still need to brace the top so I will make it so it comes off easy and fold it back.
I agree with every thing for the most part that was said before me on this topic. But I would like to add one more thing.
I know on some mowers they come with a R.O.P (Roll Over Protection) bar that does the obvious of protecting the you and the maching if a roll over occurs. The thing that I noticed with a lot of businesses and I had the same thing, and that is that they are taking them off because they have more of a tendancy to get in the way when going under trees or any other obsticles.